• Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

New to BP with a 10 gauge and hopes of a turkey

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I just took a lot of scrubbing to get it clean, that being said there are probably better ways and means of getting these things clean, I am not familiar with the tricks of the trade so to speak. I just took some pre soaked "muzzle loader cleaning patches" and scrubbed until black stuff quit coming out. Then I removed and cleaned the nipples individually and oiled them and replaced them. Ran a patch with cosmoline down the barrels a few times and put an oily patch between the hammer and nipple.
I probably need some tools more specific to cleaning this particular gun, I'm sure that would help.
Cosmoline? I wouldn’t use that unless I was going to store the gun for a few years.

Patches wet with water will cut the fouling very nicely, then use a couple dry patches. Then a lightly oiled patch, followed by a dry patch to tidy up. Use a lightly oiled patch to rub the nipple threads before returning them to their home.

Prior to loading on your next go’round, wipe inside and out with dry patches to remove any residual oils.
 
Back
Top