EC121

Here’s another Hoffman gun. It is a sawed off fowler with a back sight from 1979. It needed some sight work. With the existing back...

How about $125 shipped!

If you are only shooting once low sights are OK(if you can get your head down), but for multiple shots, it doesn't take long for the...

I replaced the back sight to avoid filing the front sight. I like the higher sights.

I have some 7f. Works fine for priming powder. Can’t say it is any better than 4f, but I’ll use it up.

Sometimes I think the crown is actually just a lathe center to hold the blank during manufacturing. We think it is a crown. Depending...

I have a Jessie Brennan(son of Jud Brennan) rifle that has the pin holes slightly coned. Looks like he was planning ahead and twirled a...

It holds the barrel to the standing breech which via the tang screw and the wedge holds the assembly to the stock.

Let me correct myself. I meant they weren’t any deeper than the other barrels on the replacement/ custom barrel market, and they were...

The rifling on GM barrels wasn’t any deeper, but the grooves were wider allowing slightly larger balls to be used. The wider grooves...

Looking at some of the word usage and grammar on the site they are foreigners.

IMO. Any rifling deeper than about .008” is marketing. It just takes enough to spin the ball. Fouling storage is not needed because I...

The crimped brushes are meant to be pushed and, unless way under bore size, never pulled. Mostly for open breeched guns.

What they said!! Depends on your budget and wants. A nicely done, used custom gun is better, but the cost goes up. The WR is...

As long as he isn’t doing it on my rifles, he can snap to his heart’s content.