You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Muzzleloading Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
If you can get them. Last year I found 1 tin in all of the WM near me this year zero.
-
Shiloh replied to the thread
Hello in camp.
Hey from Yell county Arkansas.
-
Understand that these pictures were taken with no hand spring installed. These were to show the endshake and barrel lug / frame joint...
-
Ok, so the '60 Army (U) has the spacer "installed" and the endshake is .0035" . I'll take material off if the arbor to "land" in the...
-
Thanks Smokerr and Captainkirk!!!
Anyway, here we go !!
Here's the spacer with the witness mark -
Here's the spacer in place with...
-
Join the club! Mike is a first class human being.
-
45D provides the answer, not just a one word comment that is of zero help.
I was a mechanic/technician for 30 years and 45D had to...
-
Well, your barrel lug / frame is a "given" so you start measuring for your .003" endshake ( bbl/cyl clearance) after the lug and frame...
-
I’m showing my ignorance of open top revolvers here.
I should have enough spacer/plug in the arbor hole so that I end up with about...
-
Yup, so taking an unknown spacer thickness and checking the frame/ barrel lug gap ( because the spacer is too thick) will allow a...
-
Mike:
Me thinks I need to have some idea of a starting thickness for a shim. Granted I could just put a shim in and see.
But I am...
-
Clamp a block of wood in your vise, and select a nail that the washer will just slip over, cut the head off first. Hammer the nail in...
-
Loading…
-
Loading…