Texcl2

I ended up using my super thin epoxy for the crack and titebond 2 for the splice. That epoxy is awesome but it takes 24 hours to lose...

That’s a heck of a project for a novice, good job!! The Ferguson rifle is on my bucket list. If Kibler made one I’d be all over it.

I put 4 coats on a practice stock, it is thin and has a pretty strong solvent scent. It is definitely less shiny vs truoil, the...

I’m working on my second walnut stocked kibler Fowler, this one in 16ga, I’m pretty sure the stock wood is going to be amazing once I...

So I got a 17mm punch and the wads aren’t large enough to be tight. I’m in the process off reaming it out so hopefully I can make it work.

You will have issues if the ball is too tight. With my pillow ticking and .600 ball combo I used a range rod bit that was a bad combo...

Looks like a good repair. I think the mortise was a little tight and the lock plate was forced in splitting the wood. I could b wrong...

Excellent repair work.

You did a great job, I genuinely can't even tell it happened.

Thanks, I wouldn’t doubt the stocks swelled some as well. I’m sure they were in and out of the cold while being shipped and that’ll...

Here’s my repair right after applying the French red stain, I also shaved a little off the mortise as it was pretty tight after the...

The hawken is actually a pretty complex build with the hooked breach and all. I hope he makes it historically accurate, folks will buy...

I have one lost in the USPS Twilight Zone right now. Their tracking is a joke. I'm sure it will be here eventually, no human knows when...

It’s pretty interesting, I had a load that used wasp wadding under greased felt and you could tell that load was moving and I hit almost...

I’m stalking up the same trail as you on this smoothbore safari. Wing shooting with my flintlock smoothbore will be my commitment for...