HORON

60 grains should ignite the same as any other charge. It could be the percussion caps are weak or the flash channel blocked by...

I assume you ran some patches down the barrel to remove residual oil when you cleaned it? Did you snap a couple of caps with the muzzle...

Is there powder under the nipple?

I would advise against drilling the nipple, the small hole focuses the flame from the cap and reduces blow back.

Listen to Phil! There is something else wrong. If you can't figure it out get help before you create a problem that is harder to fix!

As others have mentioned above, run an alcohol patch down the barrel a couple of times before loading, snap a couple of caps to make...

No powder coming out after you pulled the ball and tipped the barrel down sounds like you dry balled it to me?

10 gr. is enough to ignite with a clear touch hole and proper pan powder*. That's a load that I typically shoot off in my basement for...

go to 3f trip 7 if you still have problems put 5grains 4f in first, some guns dont shoot trip seven well because of poor breach plug design

Drilling the nipple probably (more likely certainly) ain’t necessary. Before loading, make sure (however you want to do it) that the...

if you want less problems always store bp guns with barrel down that way any left over oils will not sit in drum or breach

NEW DAY After i did an extensive cleaning and inspectionn i put 70 grs triple 7 2f and a lubed patch and round ball...

Excellent advice and after i pulled the ball and patch i turned the barrel down and no powder ran out so im pretty sure i had too much...

Not at my house atm. When i get home i will do more checking. Just so everyone knows after i cleaned it i took the inspection screw out...

Sounds like a good plan. After i clean tonight im gonna perform what you advised. TBH an oily barrel was what i first thought of when it...