-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
JimKim's latest activity
Help Support Muzzleloading Forum:
-
I really do not know off of the top of my head, as to the proper size of hole in the nipple. I don’t have anything handy to measure mine... -
JimKim replied to the thread Ignition Woes.It doesn't protrude into the bolster.
-
Have you checked to make sure you have the right nipple for your rifle? If your nipple is to long in the threads it can be an issue.
-
At the risk of being repetitious I would do the following: Make sure the breech is clean. It may be reduced in diameter to about 3/8" in...
-
JimKim replied to the thread Ignition Woes.I hate to assume anything, but I assume mine is like this. I have a button type breech plug. I don't believe that would make much of a...
-
-
JimKim replied to the thread Ignition Woes.A 1/32" drill slides through it. Should I drill it out with a 0.040" bit? When I clean, I use boiling water(I use a trough heater to...
-
Did you check to ascertain the hole in the nipple is clear and of the proper size? If the nipple is not the proper size and/or...
-
I bought a CVA Hawken. I got it CHEAP. It took a good bit of tinkering to get it to shoot. At first the hammer was slow. That was easy...
-
JimKim replied to the thread Need to get rust out of my bore.My barrel had a really rough spot about halfway down. I had to use a mallet to pound a patched ball through that sesectioni thought it...
