ZUG's latest activity

Eh, his biggest problem is that he's a 14 year old boy. I thought that a discussion after the first one was good enough, but he'll be on...

My brother lived in the state of Washington and as you know it does have its damp and rainy days. He shot both flint and cap guns and...

I would not let this person try to remove or install any more nipples:rolleyes:. Some people don't have the motor skills to do this...

Don’t allow them to use a wrench until the nipple is fully in, then only to tighten the last bit. If it is clean and straight it will...

What makes it a TARGET rifle? Looks like just another Hawken rifle to me.:dunno:

I don't think so but anything is possible. A range trip with both and two targets posted side by side. Alternate the caps with a...

Measured by WEIGHT. Dispensed by VOLUME. Get it right folks and quit confusing the issue. It's done this way with ALL powder. Set the...

To do the job right you need to remove the metal parts that have the lacquer finish on them and use a lacquer thinner or acetone to...

I have used Fogle's Gunsmithing 276 E. State Street P.O. Box 105 West Mansfield, OH. 43358. I made a 1911 comp target pistol and did the...

Many years ago I made a stock for my model 12 field gun that I put a roll-over comb on. I then sprayed it with a diluted mixture of...

We use so much stock finish, that we make our own. Like Tru-Oil..BLO and Japan drier from the paint store. About 10% drier..Thin coats...

Ha! ladies panty hose, where do you get that now days? When I was in the Corps back in the earl 60's.I finished my M 14 with Truoil, all...

Using steel wool at most any phase of finishing is anathema IMO. I use 3M scuff pads which come in different levels of coarseness. I...

If you do decide to repair it in the future, take it to someone who repairs jewelry. They are quite accustomed to silver-soldering...

Before I attempt to refinish the stock I would remove ALL of the existing finish that is already applied. Then I would let the stock air...