• Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

TC Senica lock

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

ike

40 Cal.
MLF Supporter
Joined
Feb 27, 2004
Messages
280
Reaction score
67
Went to shoot first time. The lock is only 1/4 inch above lipple at half cock. At full cock it doesn’t have the power to set off the cap. I repositioned the hammer but didn’t help is there another setting inside the lock. Ike
 
Went to shoot first time. The lock is only 1/4 inch above lipple at half cock. At full cock it doesn’t have the power to set off the cap. I repositioned the hammer but didn’t help is there another setting inside the lock. Ike
Ike,
A photo and a lock brand would be a huge help to get you some answers.
Larry
 
Two things to check are the nipple being mushroomed or the mainspring is weak. I had shim one mainspring with some tiny washers. You can gently chuck up nipple in a drill and cleanup the mushroomed nipple with a small file.
 
Most of the fail to fire with percussion guns is caused by a flatened nipple. As stated you can restore the knife edge by chucking it in drill and holding it up to a tool stone or fine file, The edge should be sharp.
 
Get one of these from Track of the Wolf:
Nipple, 12-28 thread, for Thompson Center Seneca and Cherokee rifles, & T/C Patriot pistol, #11 CCI cap, stainless steel
  • Cone length: 0.300"
  • Thread journal length: 0.200"
  • Overall length: 0.500"
  • Diameter of base: 0.305"
Use nipple wrench #NW-170
 
Back
Top