Steve Grentus
36 Cal.
Having trouble getting the wedge spring to compress to be able to slide the wedge out. Any help is greatly appreciated thank you
Steve
Steve
-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
1860 Pietta Army help
- Thread starter Steve Grentus
- Start date
Help Support Muzzleloading Forum:
Use a piece of hardwood or brass as a punch and tap on the spring. I'm thinking of modifying mine to ease removal and installation.
Tyler L
40 Cal
Don't worry about compressing the spring; it's pretty weak and will just flex out of the way. It's only purpose is to keep the wedge from falling out when the gun is disassembled.
Just use a piece of hardwood, plastic, or brass and give the wedge a good whack. Some are very tight from the factory.
tomatobodhi
32 Cal
There is a legend that Pietta has a 2000lb gorilla at their factory that they’ve trained to drive those wedges into their colts.
The “Pietta Gorilla” strikes again!
Seriously, though… Track of the Wolf and others sell brass wedge punches that make removing wedges much easier and won’t damage your wedge.
The “Pietta Gorilla” strikes again!
Seriously, though… Track of the Wolf and others sell brass wedge punches that make removing wedges much easier and won’t damage your wedge.
- Joined
- Apr 10, 2012
- Messages
- 615
- Reaction score
- 450
Half of a clothes pin.
You should be able to drive the wedge back to the spring lip. That is going to determine any issue to start with, heavy whacks or metal needed and ......
After that, assuming the wedge moved ok at the end of the travel, then a whack with your mallet with a bias to the spring lip should take it on out. So tap it at an angle at the top of the wedge so the spring lip gets smacked as well as the wedge.
If the wedge continues to move hard all the way to the lip then there is an issue that is going to take work to resolve or send it to 45D.
After that, assuming the wedge moved ok at the end of the travel, then a whack with your mallet with a bias to the spring lip should take it on out. So tap it at an angle at the top of the wedge so the spring lip gets smacked as well as the wedge.
If the wedge continues to move hard all the way to the lip then there is an issue that is going to take work to resolve or send it to 45D.
I just whack the thing out with a small rubber mallet. When a gun is newer I find you need a dowel and whack it with the mallet, but after it has been done a few times the mallet is all it takes. 1 good pop and it is out of there.
