• Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

nipple wrench measurements

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Jun 21, 2024
Messages
94
Reaction score
88
Location
MIDWEST
I am going to try my luck at the local machine shop for a hardened steel nipples wrench for my .39 cal 1851 Navy and my Whitneyville dragoon (both Uberti). What are the exact size measurement for the of these nipples. I've seen everything thrown around but most .096 for 1851 Navy and 209-something for the dragoons. Cab anybody help me with the measurements I need for the machinist?
thx in advance
lp
 
Lonepine, I too had bad luck with nipple wrenches until I bought the Chapman wratcheting set. Worth every penny. Look them up.
 
I am going to try my luck at the local machine shop for a hardened steel nipples wrench for my .39 cal 1851 Navy and my Whitneyville dragoon (both Uberti). What are the exact size measurement for the of these nipples. I've seen everything thrown around but most .096 for 1851 Navy and 209-something for the dragoons. Cab anybody help me with the measurements I need for the machinist?
thx in advance
lp
This is one of the few applications that are suitable for a Dremel tool and the metal cutting discs.

Get a 3/16" or 5 mm nut driver for one of the hex drive screwdrivers. You can use the flats of the nut drive to locate the slot. Use the metal cutting disc of a hacksaw to cut down the height of the cone of the nipple. Cut the second slot the width of the nipple flats. A micrometer or a digital Vernier calipers can be used for that measurement. Cut out the waste between the slots and fit the nipple to the modified tool. The nut driver can be turned down on a grinder to fit the cylinder of the revolver.

Below is a photo of a modified nut driver and a small hex drive impact tool. Sadly no longer available at Harbor Freight.

Impact Tool2.JPG
 
This is one of the few applications that are suitable for a Dremel tool and the metal cutting discs.
That is how I make mine. Custom fit the 1/4 drive socket to which ever nipple I need one for. The loose socket fits winged musket caps and the one on the handle breaker bar fits most cap & ball revolvers. I have never had one break or round off the nipple.
Nipple wrench.jpg
 
Back
Top