Need to get rust out of my Bore

Wireforhire said:

This was a post I made back Aug. 29th. The bath isn't as hard on the metal as vapor rust and it is amazing. Citric acid from Amazon the other components from any store. No real soak time required less than an hour. Better to not let it stand in the barrel unlike Vapor rust. ZEE

Click to expand...

Davey Boy said:

Since it is not a closed end barrel

tie a cloth or steel wool or something on a long string, run the string through the barrel, pulley on one end, drive pulley on the other hooked to electric drill

tie both ends together

put your compound on the cloth or steel wool and set it up so it can pull it through the barrel, go around the pulley and then you can just watch it clean and polish

should be fun not tedious

Click to expand...

morehops52 said:

Most of the stuff mentioned here will work on the surface rust and shallow pits. I've read on this forum over the years that many have barrels that look like old gas pipe but shoot incredibly well. Get the surface stuff off so it looks better to you and then go shoot it and see how it performs.

Click to expand...

BoomStick said:

Valve grinding compound will remove the high spots, might smooth edges on some of the pitting but pits will remain. Accuracy may be fine, but pitting will hold onto fouling and crud will build up. Still a shooter but swabbing every few shots may be required.

Click to expand...

Des52 said:

Go to the car parts store and get the valve grinding compound. I use the two part with course and fine pastes. Get a smaller jag and some green scratch pads, cut a small square, put the grinding compound on the square and polish away. I check after 200 strokes with each to see how much more is needed.

Click to expand...

French Colonial said:

Shoot it!!!

Click to expand...

Colonel Blimp said:

The " A&H Laundry" web site

https://www.armandhammer.com/laundry/liquid-laundry-detergent

lists 15 different "Laundry" products........Which was yours?

Click to expand...