Search results

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Tumbledown

    Does one need to apply oil or ballistol INSIDE the lock?

    That's why surfaces contacting each other should be well polished. No one here has ever said to apply grease.
  2. Tumbledown

    Use of fine shot in colonial America

    Shot and rifles don't work together well, and colonial rifles were a relatively small bore compared to militia muskets, so no, it's not a safe bet.
  3. Tumbledown

    Does one need to apply oil or ballistol INSIDE the lock?

    Packing with grease is the last thing anyone should be doing. It attracts and holds dirt. If you're applying so much it "cushions" the lock, you are actually inhibiting its operation.
  4. Tumbledown

    Failed attempts at a rubbed back / French grey finish

    If you want blotchy, use the naval jelly then apply a solution of salt and vinegar. I brushed it on, thoroughly wetting the metal and letting undissolved salt crystals cling to the barrel. I let it sit a couple of days, then wiped with a dry cloth to take the crusty stuff off. This was the...
  5. Tumbledown

    Failed attempts at a rubbed back / French grey finish

    Sand the metal bright using 220 grit paper, then apply naval jelly, let sit 15 minutes, rinse off and dry. Repeat the naval jelly if you want it grayer.
  6. Tumbledown

    Failed attempts at a rubbed back / French grey finish

    Not a coating, but a treatment. Naval jelly is phosphoric acid.
  7. Tumbledown

    Does one need to apply oil or ballistol INSIDE the lock?

    You don't need Ballistol. You don't need to disassemble it, either. I clean with hot soapy water, rinse with hot water, shake off the excess, then dry. I have a small bottle of oil with a needle tip, I oil the tumbler, sear, and frizzen pivots, just a tiny bit will do, and work the mechanism to...
  8. Tumbledown

    New to the forum from Maine

    Greetings from Brunswick, Maine. Whereabouts are you?
  9. Tumbledown

    Hammer gets stuck on the half cock: diagnosis?

    You're not pushing the sear up fast enough. Hold the lock firmly with your other hand and push the sear with authority.
  10. Tumbledown

    For anyone considering an Indian manufactured Flintlock

    Your logic is flawed. Proofing is to ensure it is safe at a *normal* charge. If the barrel can withstand a double load, it is safe at normal levels. You're assuming it's safe from the start.
  11. Tumbledown

    For anyone considering an Indian manufactured Flintlock

    It's a blank. There's nothing to obstruct the barrel, and nothing to cause a spike. Yes, there's the paper from the cartridge *if* that's rammed down, but that is not going to offer any resistance.
  12. Tumbledown

    For anyone considering an Indian manufactured Flintlock

    Pedersoli is going to make a LLP Bess? Or retool their SLP? Because that's what my comment specifically referred to when tenngun said you could get a Bess from them.
  13. Tumbledown

    For anyone considering an Indian manufactured Flintlock

    It's also arrogant and condescending. And expected from certain people.
  14. Tumbledown

    For anyone considering an Indian manufactured Flintlock

    You can't get a Bess from Pedersoli. They don't make a Long Land Pattern, and their SLP is an inaccurate immitation.
  15. Tumbledown

    Advice on adding a sling to a Pedersoli brown bess carbine.

    Front swivels should have their own barrel lug.
Back
Top