-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
Search results
Help Support Muzzleloading Forum:
-
O
Set trigger problem
I'v had this problem on a few rifles over the years and the most common fault is the sear ,when struck by the trigger ,could be flying up and hitting wood and bouncing back down ,over the fly into the half cock notch . remedy'''releave wood in sear hole above sear in mortice . to check ...- Old Dave
- Post #13
- Forum: The Gun Builder's Bench
-
O
Tell me about a 32 cal
I,ve been shooting one of Ed Rayl,s little 3/4 inch .25 cal. barrels. siler deluxe flinter on the side .(42 inch barrel) ramrod is sanded down 1/4 inch hickorey . hornady no. 3 buckshot .250 dia. .015" ticking on top of 25 gr. gox fffg powder . thumb nail size groups at 25 yards . killed a...- Old Dave
- Post #18
- Forum: Flintlock Rifles
-
O
.54 #5 load info needed
let's go rite to the wads , 50 years ago I got a 14 ga gun . no wads were around so I was instruced verry carefully powder then 3 sheets toilet paper tamped till rod bounced shot on top of that then 1 sheet on top of that pressed fermly down . the paper is pretty well shredded upon firing...- Old Dave
- Post #18
- Forum: Smoothbore
-
O
What size touch hole works best?
I use a 1/16 inch drill bit for the touch hole in a stainless steel vent liner in all my flintlocks. Good luck. Old Dave- Old Dave
- Post #2
- Forum: Flintlock Rifles