.32 Kentucky rifle and water jug test

[David LaPell]

I did a test was with the Pedersoli Kentucky Rifle using 1 gallon water jugs. four of them lined up, again, same load as before, 25 grains of FFFG Schutzen, and a .010" patch. The .311" roundballs I used were cast from .570" Hornady balls I recycled and melted down. The jugs were shot from about 7 yards away, the .311" ball went through the first three jugs, entered the fourth and bounced off the backside of the fourth creating a slight dimple. The roundball suffered no deformation at all.

The four water jugs right as the .311" ball hits the first jug.

The dimple in the back of the fourth jug.

The .311" ball after the water jug test.

 

[longcruise]

The lack of deformation is very interesting. Wonder what would happen as the charge increases??

 

[stubshaft]

What's interesting is that there are no indentations or marks showing that the patch was in contact with the ball.

 

[kyron4]

Saw your video on YouTube, interesting results. Any idea on the velocity with this load ? I would have thought some deformation. However, with my 50 cal pistol with 25 grains of 3F, the ball don't deform either. I estimate velocity at around 700-750 fps out of my pistol.

 

[Rifleman1776]

Interesting but not sure what it proves.