Brownie
36 Cl.
If you were to precut your patches square or round what size would the be for a 32,45,50 caliber. Also, where can I get some sort of nipple cover for while I am walking.
-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
couple of questions
- Thread starter Brownie
- Start date
Help Support Muzzleloading Forum:
stubshaft
40 Cal.
- Joined
- Mar 5, 2010
- Messages
- 569
- Reaction score
- 63
I have an old arch punch that cuts 1 1/8" patches that I use for all of the calibers you have listed. As far as a nipple cover, I just drill out a lead ball and slip it over cap and let the hammer rest on it while walking around.
look a pre cut patches and that will tell you. too large a patch may get caught up in your loading jag... about the cover... do you want to cover a capped nor uncapped nipple??
- Joined
- Mar 13, 2020
- Messages
- 7,350
- Reaction score
- 20,507
- Location
- On the Border in Idaho looking at BC
drill another hole and attach a thong tied to the trigger guard and it won't get lost in your pocket with the other balls.
It's the patch thickness that's the crucial factor more so than the size. Thickness is dependent on the projectile size versus the bore dimension. These factors vary even within a given caliber.
For covering the nipple while walking I use a spent .22 casing. An LR case works fine but I prefer a short. That was a suggestion from another member a couple years ago I tried and it worked. Can't remember who it was or I'd give them credit for it.
Phil Coffins
69 Cal.
I wonder what Kit Carson or the rest of the frontier rifle men used?
- Joined
- Feb 27, 2013
- Messages
- 310
- Reaction score
- 422
Deer Creek Products has cap covers and about 1" square or round would cover those calibers.
longcruise
70 Cal.
For a cap cover, a small round piece of thickish leather on a tough piece of string or a piece of Leather lace tied to the trigger guard and placed on top of the capped nipple with the hammer holding it down. It will fall away when you bring the hammer to half or full cock.
For size of precut patches if you go with the circumference of a ball for minimum width of a square or round patch, it won't be too small.
C=pi x diameter so for 50 caliber:
C= 3.14 X .50 = 1.57" doesn’t have to be exact. If you round it to at least 1.5" it will not be too small and a little bigger won't hurt.
