FYI, 'BuckHorn Traders' has some decent ML products, and makes some leather items like flint wallets, hammer stalls, etc...I recently got some Hammer Stalls from them and while good quality leather and stitching, they were actually built for the typical larger flintlock sized frizzens, and were just way too tall and wide for the smaller sized frizzens on TC locks, would fall off, etc.
So I measured and recut and restitched and finally got one to the correct dimensions to snugly fit a TC frizzen...but they looked exactly like what they were...something modified with a utility knife on the floor of a garage!!
So I talked with Bob, the owner of Buckhorn Trader's, explained what I needed and specified a small punched hole at the top for a rawhide lace tie, mailed him a TC frizzen as a template, and he made some perfect fitting, good quality leather hammer stalls for the TC Flintlock...hunted with one this morning and they're outstanding.
(I think I've heard that the Lyman frizzen is the about the same dimensions as the TC so if true, they should fit them also)
I'll try to get a closeup photo in case any TC or Lyman fans want to see one up close
So I measured and recut and restitched and finally got one to the correct dimensions to snugly fit a TC frizzen...but they looked exactly like what they were...something modified with a utility knife on the floor of a garage!!
So I talked with Bob, the owner of Buckhorn Trader's, explained what I needed and specified a small punched hole at the top for a rawhide lace tie, mailed him a TC frizzen as a template, and he made some perfect fitting, good quality leather hammer stalls for the TC Flintlock...hunted with one this morning and they're outstanding.
(I think I've heard that the Lyman frizzen is the about the same dimensions as the TC so if true, they should fit them also)
I'll try to get a closeup photo in case any TC or Lyman fans want to see one up close
