Co worked gave me a partial CVA kentucky pistol kit he found in a clean out and I can't seem to figure out how the ramrod thimble connects to the barrel tenon, or if it doesn't, where and how should it be mounted. Tenon and thimble we're ordered from Deer Creek, they weren't on the pistol
-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
CVA kentucky pistol barrel tenon question
- Thread starter Mnt rifle
- Start date
Help Support Muzzleloading Forum:
It doesn't connect to the tenon.
A small hole is drilled in the center of the ramrod channel through the web into the barrel channel.
The screw goes through the web from the barrel side to hold the thimble, the installed barrel covers/hides the screw
A small hole is drilled in the center of the ramrod channel through the web into the barrel channel.
The screw goes through the web from the barrel side to hold the thimble, the installed barrel covers/hides the screw
64Springer
75 Cal.
You have to drill a hole through the stock and tenon and pin the barrel/tenon to the stock.
There should be a pin with the kit.
There should be a pin with the kit.
