Derringer back from the dead

[1942farmall]

It's been 20+ years since I've played with black powder or built any firearms.
I built quite a few many moons back.
I found part of an old CVA Derringer in a box of parts that was my late father-in-laws after he passed.
It was pretty beat up and had been sitting on my bench for about 3 years.
Two weeks ago I got the itch and started the rehab.
I ordered what was missing from Deer Creek.
This was mostly hardware.
I know it has no value but im really enjoying this build.
I had to do quite a few plugs or inlays to fix dents, damage, or previous errors.
Still lots to go but this is before and after.
The barrel still needs quite a bit of work and the trigger guard is only roughed out. Haven't decided on how to finish the stock.
Might do a medium brown stain and tung oil.

 

[poker]

Nice job

 

[necchi]

Laser cut?
If not, what mill/cutter did you use?
It's an interesting project, the inlet's are obviously machined from a traditionalists view, but nicley done.
As a forensic construction,, the wood/metal interface of the lock, tang and trigger guard are off just a bit.
Not bad, it is a kit,,
The machined inlets DO fit the stock profiles,,
So how'd you do it? Your inlet "craftsmanship" is superb, please share with us,, honest,

 

[JohnL]

Good job! I, too, have one of those in a box in need of attention. Perhaps I’ll get on that in 22!

 

[deermanok]

Looking good.

 

[1942farmall]

Laser cut?
If not, what mill/cutter did you use?
It's an interesting project, the inlet's are obviously machined from a traditionalists view, but nicley done.
As a forensic construction,, the wood/metal interface of the lock, tang and trigger guard are off just a bit.
Not bad, it is a kit,,
The machined inlets DO fit the stock profiles,,
So how'd you do it? Your inlet "craftsmanship" is superb, please share with us,, honest,

All the rounds were drilled with forstner bits and then plugged with contrasting wood. The two teardrop inlays were fitted by hand with carving chisels and a Dremel.

 

[russellshaffer]

Fun project - looking good.

 

[cynthialee]

I love these little guns. I have a few BP derringers. I keep one in my desk drawer next to me.
I think I have rebuilt or repaired at least a half dozen of them over the years.
My favorite is a 12mm little dude from Spain with a 3 inch barrel. Says 12mm but it measures 11 by my tape measure. (don't have calipers) Fits a .380 patched ball. Forgot how much powder I figured out to put in it. (don't lose your shooting notes in a move....it will leave you lost and scratching your head over the loads your guns need)

That little pistol you are working on is a fun one. Had a pair of them but sold them off to put more money in my rifle fund.

 

[Winchester97]

Pretty darn nice woodwork there! Keep us posted.

 

[1942farmall]

Decided to flute the barrel since one side had a serial number and 'Spain half sanded-off. You could only see the tops of the letters and numbers.
I re-stamped the number on the bottom that will be under the stock. Turned out good.
I'll paint infill the flutes black after I blue or brown the barrel.

 

[JohnL]

Decided to flute the barrel since one side had a serial number and 'Spain half sanded-off. You could only see the tops of the letters and numbers.
I re-stamped the number on the bottom that will be under the stock. Turned out good.
I'll paint infill the flutes black after I blue or brown the barrel.

I like this!!