A little while back I rechecked my sight in for the after Christmas flint lock season. Flint was well-worn down but the gun went off every time ; but the frizzen didn't pop fully open. Last week I replaced the flint and got it all proper but the frizzen still pops open to a tad past the flint after testing. Is this something needing attention and if so what do I tweak? Pry the spring out a tad to make it stronger or what? All replies appreciated.
-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
Frizzen not completely opening
- Thread starter mrd
- Start date
Help Support Muzzleloading Forum:
ArmorerRoy
40 Cal
I had that happening on one of my guns and it was the frizzen screw that was too tight. About a half turn loosened it up.
A little oil on the frizzen pivot will also help. I have run into the spring being too strong and the frizen not opening. To weaken the spring a little grinding on the edge of the springs bend will weaken it just don't get it hot to remove the temper, grind, quench in water, test repeat till the spring is just right.
Something many miss, is how fast a frizzen rebounds. Place you thumb at the front to the frizzen with it open. **** the gun, and cycle the lock by pulling he trigger. You will most likely find that the frizzen is contacting your thumb before rebounding. It just happens so fast, you don't see it.
Update , Sorry for the delay but got it fixed. Removed the frizzen screw and found it not to be completely tight and had a little crud/rust on the screw , so I cleaned both screw and frizzen hole and lubed. Also found spring screw needed a tad more tightened. Don't know if it was one or a combo to cause the problem , but it works great now. Thanks for any and all help!
Also, remember to put some grease on the frizzen toe and the top of the spring where it slides.
ADK Bigfoot
ADK Bigfoot
Similar threads
