Making cane/bamboo powder measures

[Aggie1105]

Howdy All,

I was able to get some naturally dried cane segments from near my pond. I figured it would be fun to make some fixed powder measures out of them. Does anyone have tips for removing the bit of dried tissue from the hollow inside of the segments? I figure it needs to be sanded a bit on the inside to make it smooth. Also is there a preferred way of finishing them to preserve them or do people mostly just use them as is?

Happy to have a fun side project. I’m not a master craftsman so thanks for any tips anyone can provide!

 

[French Colonial]

Howdy All,

I was able to get some naturally dried cane segments from near my pond. I figured it would be fun to make some fixed powder measures out of them. Does anyone have tips for removing the bit of dried tissue from the hollow inside of the segments? I figure it needs to be sanded a bit on the inside to make it smooth. Also is there a preferred way of finishing them to preserve them or do people mostly just use them as is?

Happy to have a fun side project. I’m not a master craftsman so thanks for any tips anyone can provide!

A round file works pretty good, you can also take a small dowel rod and cut a slot in it, put some sand paper in the slot, chuck it up in a drill and sand the inside, doesn't have to be perfectly smooth.

 

[Banjoman]

I’ve always left the outside as is.

 

[springfield art]

Howdy All,

I was able to get some naturally dried cane segments from near my pond. I figured it would be fun to make some fixed powder measures out of them. Does anyone have tips for removing the bit of dried tissue from the hollow inside of the segments? I figure it needs to be sanded a bit on the inside to make it smooth. Also is there a preferred way of finishing them to preserve them or do people mostly just use them as is?

Happy to have a fun side project. I’m not a master craftsman so thanks for any tips anyone can provide!

How 'bout a Dremel tool? This is a neat project! Let us know how it goes! Like the idea!!

 

[Aggie1105]

A round file works pretty good, you can also take a small dowel rod and cut a slot in it, put some sand paper in the slot, chuck it up in a drill and sand the inside, doesn't have to be perfectly smooth.

I like the dowel rod and sand paper idea! I have both on hand so I’ll try this first. Thanks!

 

[Aggie1105]

How 'bout a Dremel tool? This is a neat project! Let us know how it goes! Like the idea!!

Dremel tool would probably be the fastest & easiest but I don’t have one on hand. Since it’s just a side project I’m trying to avoid unnecessary purchases haha. Thanks for the idea though!

 

[Banjoman]

Here’s one I made along with a vent pick and turnscrew.

 

[Kentuckyjed]

You can use a drill bit of equal size to clear the nodes and in between them. You might have to somewhat roast the cane over a fire or torch to help get the moisture out or it will eventually split.

 

[ronaldrothb49]

I used to make powder measures out of river cane, no longer have access to it. I would just use a drill bit close to the size of the hole to clean up the inside if necessary. Never used any kind of finish on them because I wanted the more primitive look of I lost my measure so I used whatever I could find to replace it. Still have several around for over 30 years that still look fine.