No. 10 capper that fits a Revolver Needed.

[peashooterJoe]

Anybody know if a Company or individual makes one to actually fit no 10 caps. I have the Cash Capper,brass stick capper (6 different manufacturers) none seem to fit. They turn side ways, wrong way. I have to put them on with my fingers, doen't work too good in the cold. Opinions suggestions, referrals, thanks all.PeashooterJoe.

 

[Rebel]

Make you a Leather capper for the #10 caps. They work fine.
Course if this is for a revolver then they may not work so well.

 

[peashooterJoe]

Thanks, but it is for a revolver.

 

[Tight_Wad]

Depends what revolver you have.

I use a Ted Cash snail-type capper perfectly well on my Ruger Old Army and Rogers & Spencer. The nipple cut-outs on my Remington are too small to take the snail capper though.

Tight Wad

 

[peashooterJoe]

I own two Ted Cash snail types and the No 10's turn sideways in it. The several bar types do same thing. Do you use no 10's in the snail type with no problems?

 

[Tight_Wad]

I do. I have two Ted Cash cappers, one filled with #10 caps and the other with #11. I use Remington caps - the #10's are slightly longer than the #11's though both are the same diameter.

CCI make them differently with both 10's and 11's being the same length but different diameters.

If you aren't using them already, try Remington #10 caps - being slightly longer I've found they're less inclined to fall over sideways.

Hope this is of help

Regards

Tight Wad

 

[peashooterJoe]

Hmm. Seems the current CCI's No. 10 are shorter that the No. 11's. I'll try the Remington in No. 10 thanks for the Heads up on the CCI. PeashooterJoe..