Parts and instruction.

[romoshka]

I am BP ignorant though I did go to the range with my father once a long time ago. I acquired his BP guns and equipment at his death 40+ years ago. This included a CVA Ky rifle kit and Ky pistol kit. The pistol kit was all in an old candy tin so manufacturer isn’t known. Now retired and with a small hobby machine shop I’d like to tackle these. The rifle kit appears to be complete to include a nice instruction booklet and all drilling, tapping, deburring and chamfering has been accomplished so it looks like a rather straight forward assembly process. Now the pistol is another story. There is a faded instruction sheet but this barrel doesn’t match the instructions which refer to a finished barrel. This barrel will require it to be drilled and tapped for the drum. The tang on the barrel is much too long and straight as an arrow thus some cutting, heating and bending will be required. Also dovetails will need to be cut into the barrel for the front and rear sights. Also there isn’t a lock for it.
So my questions are: 1.Where do I source a lock? 2. As this barrel will require some machine work would the instructions give some indication of where the drum should be located or must I determine that once the lock is installed? 3. Guidelines for heat tolerance and treatment of the tang. Thanks any and all who can offer some assistance.

 

[2 shots]

we will need pictures to help you. does the pistol have a stock??

 

[BoomStick]

And a photo of the instructions, even faded, may give some idea.

 

[romoshka]

we will need pictures to help you. does the pistol have a stock??

 

[wiscoaster]

Ummmmm ..... unless you're doing this for some sentimental reasons that outweigh any practical considerations, the amount of time and effort and expense you're going to have to put into making this a shootable gun is going to far outweigh just buying a new and complete kit or production gun.

 

[ZUG]

You might not like what I am going to say but if it was mine I would not waste any money on this bunch of useless parts. I would put it up for sale and buy yourself a bottle of a adult beverage for the holidays.

 

[romoshka]

And a photo of the instructions, even faded, may give some idea.

Ummmmm ..... unless you're doing this for some sentimental reasons that outweigh any practical considerations, the amount of time and effort and expense you're going to have to put into making this a shootable gun is going to far outweigh just buying a new and complete kit or production gun.

Well I’m retired, have a machine shop and time. Looks like a lock is ~$65 and that’s the only part I need. I think one brass ramrod thimble is missing but I’ll just turn that out. The machine work is well within my capabilities. Will have to carefully measure location of the drum.

 

[romoshka]

You might not like what I am going to say but if it was mine I would not waste any money on this bunch of useless parts. I would put it up for sale and buy yourself a bottle of a adult beverage for the holidays.

I may not agree with what you have to but I’ll defend to my death your right to say it. I’ve got plenty of adult beverage. I’ll press on

 

[BoomStick]

You could elect either flint or percussion -either way you have to find the right place to drill the barrel.

 

[smo]

Do not be discouraged, they will shoot.

 

[mikesto44]

Take the challenge it will be fun. Plus you will learn a lot. Your retired so its just a fun project. You might be able to get a lock from Log Cabin shop in Lodi Ohio.
Just measure the length of the in let an see what they have. Or check E Bay. Good luck.

 

[smo]

Deer Creek Products is another great source for older CVA & such parts..

 

[R Ellis]

Do it and have fun also Deer Creek may have the lock that will fit without much inletting