WANTED Steel 1/4” X 28 tpi nipple

[Phil Coffins]

I’m putting an original rifle that was found in a wall back together. One of the parts needed to make it suitable as a wall hanger is a steel nipple. All I have are stainless and that would look out of place. A worn out, battered, and or rusty one would be fine or I can make a nice one that has these traits. If you have something in your junk drawer that you will part with let me know. 1/4” X 28 thread is what it needs.

 

[Dryball]

Can go one better... Have old one made of brass if you want

 

[Mark Herman]

If not the brass I have old used up nipples. Let me know.

 

[Phil Coffins]

Thanks BJCollings the brass isn’t what I’m looking for.
Mark I sent a PM and used up steel nipple would fit my needs. How shall we proceed?

 

[Mark Herman]

Phil,
I haven't forgotten your nipple. Been ill but am up and around now. Will get it out, need an address.
Mark

 

[Zonie]

Phil,
I haven't forgotten your nipple. Been ill but am up and around now. Will get it out, need an address.
Mark

Phil:
Do not post your address here. Send Mark a Private Message to give him any personal information.

 

[Phil Coffins]

Mark, thanks but I just went ahead and made one. Not that hard, I‘m just lazy.
Zonie, I understand thanks.