toe plate screws

[olskool]

i need a little help. i have done several Kibler SMR and i always cut for a toe plate. i had screws a friend had but now we are both out of them. i have ordered screws a couple of times but they are not right. they need to be short enough where they won't run into the butt plate screw or hit the butt at the back screw. the ones i have are #6 and they are just too big. does anyone know where i can get the right ones? thanks for the help......................

 

[rchas]

McMaster-Carr can supply just about any size wood screw. They are zinc plated, but that can be burned off with a torch (hold your breath...). Track of the Wolf has small packs of unplated screws.

 

[SDSmlf]

I haven’t order any in a while (all stocked up for what I need and use), but I have ordered from Blacksmith Bolt and will again.
https://blacksmithbolt.com/collections/6-slotted-flat-head-steel-wood-screws
You could also likely get what you need from TOW, but I prefer to buy a variety in bulk when I need screws.

 

[deerstalkert]

tag

 

[Old-Duckman]

I haven’t order any in a while (all stocked up for what I need and use), but I have ordered from Blacksmith Bolt and will again.
https://blacksmithbolt.com/collections/6-slotted-flat-head-steel-wood-screws
You could also likely get what you need from TOW, but I prefer to buy a variety in bulk when I need screws.

Nice site, I did not know about it, thanks!

 

[ord sgt]

If I remember correctly, #3 size screws are needed. Toe plate is thin and not under any stress. Countersink if needed.

 

[The Crisco Kid]

Log Cabin Shop:

https://www.logcabinshop.com/catalog.php?path=&product_id=25884

 

[tenngun]

Track offers a lot of plain steel screws

 

[2 shots]

dixie also

 

[olskool]

i ordered from track, i think they are right,,,,,,,,,,,,,,,,,,

 

[Bucolic Buffalo]

I had done some thought about this after I ran into the same problem. That perhaps I was just a bit too close to the buttplate. And, that just maybe having a screw that close, even though small, might cause the toe to crack at some point in the future.

It almost seems like leaving too much hanging out there without a screw in it. I am not sure what is the best solution.

 

[Griz 54]

i need a little help. i have done several Kibler SMR and i always cut for a toe plate. i had screws a friend had but now we are both out of them. i have ordered screws a couple of times but they are not right. they need to be short enough where they won't run into the butt plate screw or hit the butt at the back screw. the ones i have are #6 and they are just too big. does anyone know where i can get the right ones? thanks for the help......................

Muzzleloader builders supply