Capt. Jas.

Breech plug tang inletted and flushed. Also got the "LONDON" engraved on the barrel.....

Had a chance to start in on inletting the barrel. Used a ball cutter to remove the bulk of the wood and will finish the inlet by hand...

Although anything produced can throw out a problem child every now and then, Kibler takes care of those if they pop up better than any...

That stuff is full of petroleum distillates. I prefer a natural ingredient mix like Montana Pitch Blend

Hi, Under no circumstances use raw tung oil or raw linseed oil on any gun stock. If you want to use raw or pure tung oil, mix it with...

Per their websites, Track's fowling piece kit STARTS higher than a quick ship listed on Jim's website right now. You will also be light...

Not only is the Kibler fowling piece easier to assemble and finish, it has much better architecture and design, better lock and...

USPS is one of the fed agencies that needs to be looked at by Trump.

I really dislike installing a butt plate. The only part I dislike more is installing a rear ram rod pipe. >:( At any rate, I spent...

More tedious work that I like to get out of the way first.....butt plate inleting in progress.....

You also need to add Rupert shot to that. Much prior to the American Revolution. Here's some out of Blackbeard's Queen Anne's Revenge...

Correct, Most of the Swan shot I've seen would be considered a smaller buck shot by today's standards.

It shouldn't as swan shot was cast and a pretty good size also.

Wanted to finish assembly of the two piece breech plug today. The barrel is tapped 1 1/8"-12 and I had machined a plug to use during...

Took a deep breath, put a brass mandrel inside the bore, and used my press and new proof mark tools today......If I mess this up the...