skwerleater
40 Cal
- Joined
- Nov 9, 2018
- Messages
- 397
- Reaction score
- 571
What Freedom said is a good idea. I have done it on mine. File a bit ( very little) off the rear of the tang. Will prevent the wood behind it from chipping out.
-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
Kibler Gap Question
- Thread starter CascadeRob
- Start date
Help Support Muzzleloading Forum:
bladegrinder
32 Cal
I had the same kind of issue on my colonial build, here is the thread. It worked out great.
Thread 'Started my Kibler Colonial...'
https://www.muzzleloadingforum.com/threads/started-my-kibler-colonial.143961/
Thread 'Started my Kibler Colonial...'
https://www.muzzleloadingforum.com/threads/started-my-kibler-colonial.143961/
- Joined
- Jan 26, 2019
- Messages
- 478
- Reaction score
- 369
I’d bed it with accraglass. Not traditional but I bed all my cubs at the breech end.
- Joined
- Nov 1, 2018
- Messages
- 3,854
- Reaction score
- 2,886
Are you talking about the gap at the bottom of the bolster ? Beneath the touch hole?
Looks ok to me.
If you’re concerned about it, you can always put a thin coat of wax in the barrel bed, won’t hurt or help anything much.
Looks ok to me.
If you’re concerned about it, you can always put a thin coat of wax in the barrel bed, won’t hurt or help anything much.
- Joined
- Nov 1, 2018
- Messages
- 3,854
- Reaction score
- 2,886
I’d ask Jim about the accraglass, that can cause issues if it’s bedded too tight.
And if I remember Kibler said to give it a little bit of a bevel (which I also did).
I cut all of my gap closing shims out of the same wood as my stock and orientate the shim grain to be the same as the place being filled.
Well, not always from the same stock wood, on this pre-carve I didn't have any scrap wood from the stock so I usewhat I had on hand which was plain maple.
Once the fix was done, I drew in the curl to match the original wood.
Well, not always from the same stock wood, on this pre-carve I didn't have any scrap wood from the stock so I usewhat I had on hand which was plain maple.
Once the fix was done, I drew in the curl to match the original wood.
A I see it you are whistling in a wind storm. I dont think your group will be off at all with this issue. Great shooting.
