- Joined
- Mar 6, 2022
- Messages
- 181
- Reaction score
- 213
Hole punch
- Thread starter Garbear34
- Start date
Help Support Muzzleloading Forum:
Where’d you acquire said punch? Never knew such creatures existed.
- Joined
- Mar 6, 2022
- Messages
- 181
- Reaction score
- 213
You're going to laugh. Amazon. Normally used for the scrap book crowd. I have a couple orginally i used for paper cartridge for my revolvers. I have different sizes for that. Even a 1 inch for making paper cartride for a modern muzzloading shotgun pistol from American gun craft. Ive got on a smoothbore kick.
Attachments
Last edited:
I’ll have a looksie on the old Amazon. Just starting the smoothie process myself. This smoothie greenhorn thanks you.
- Joined
- Mar 6, 2022
- Messages
- 181
- Reaction score
- 213
I scoured and read brittsmoothy replies and helped a ton in the smoothbore threads. I've had best results so far 70 grains powder 3-4 of my over shot cards in top of powder 1 1/8 oz shot then 2 cards on top. Hasn't mattered much if using #8 shot or #5 shot. That only size i have. I need to do more work though with my round ball loads.
Now i want a flinter smoothbore
Lets us know how your journey goes.
.
Pics do not show punch as far as I can see,
- Joined
- Dec 16, 2020
- Messages
- 234
- Reaction score
- 873
Do you have a brand name or Amazon link?
- Joined
- Mar 6, 2022
- Messages
- 181
- Reaction score
- 213
Just ordered the highest rated and reasonably priced ones off amazon. I use 3/4 inch for my 12 gauge shotgun but before that used that size for making the bottom of my 44 paper cartriges. I have two others one for cutting the disks for my .36 caliber paper cartriges. Check amazon
Have you tried to cut cloth patches with it? If so how'd they turn out?
I use a #11 Osbourne punch for my 20 bore. A set of the punches from Harbor Freight is pretty cheap. I use heavy poster board for my guns.
https://www.harborfreight.com/9-piece-hollow-punch-set-3838.html
https://www.harborfreight.com/9-piece-hollow-punch-set-3838.html
Last edited:
- Joined
- Mar 6, 2022
- Messages
- 181
- Reaction score
- 213
No. I also have3/4 hollow punch I use with a hammer. I’ve uses that for wool felt and heavy card board.
Thank you
Hole saws. With the teeth ground off at an angle. Either use it by itself and whack it with a dead blow hammer or mount it on an arbor without the drill bit and use your drill. A little practice and you can keep it from walking on ya and you can cut through a a good tack of felt, cloth, leather, cardboard, or what ever.
