Search results

Marking the range rod.

Traditions 3 piece brass is convenient and if you have a very long barrel get two. TRACK of the wolf and others have 1 piece stainless.

I’ve been thinking about getting a receiver hitch mounted vise.

Where do you get the TAPS for these sizes?

Message sent

Sorry, I see the shipping answer.

It is hard to tell from the image. What condition are the cavities and how much for shipping to 71105?

I agree. The mould is not closing tightly. Gently tap the metal part of your handle with a wooden mallet while squeezing the handles closed. This should help close the moulds. Some moulds just need help. Also Frosted = Hot

1/4 x 28 for Thompson Center is a short shank nipple both top and bottom. They are commonly available in box stores.

A simple polish is plain white toothpaste. Put it on a patch rub it in well. You might want a little water. Run it in and out on a cleaning jag. JB Bore Paste makes good products too.

I have had this problem with CVA rifles. The hammer is offset and not getting a good strike. I have shimmed hammers outward and I have bent them inward. Some rifles STILL require a double strike to fire. The first hammer fall “seats” the cap on the nipple and the second strike usually fires...

Yes. Thanks!

Cannot figure out PM How are the Minnie balls sized by numbers? What fits a .50 caliber rifle? Will 1:60 stabilize it? Thanks, Chuck

Smoke/soot the trigger levers. Use a candle to soot the parts. Reinstall and work them a few times. Remove them and look for signs that they are rubbing on the stock. If you see soot on the stock, remove a small amount of wood at that area and retest with more soot. This should eliminate your...

I’ve been swabbing with bear grease from October Country between shots. I use a strip of pillow ticking about six inches long attached to the ramrod to apply it. Just don’t use too much. I’ve gone five months without cleaning but plan to clean soon.

I like using a 3 piece sectioned brass range rod for high volume shooting with the Scouts. One of the things that I have learned is that I can take a socket from my 1/2" impact set and place it on the top section of the rod. I can then slide the socket against the handle of the rod to act as a...

I would like one. My 50s should roll out quite nicely.

1. Treat several papers at home. 2. From the papers that pass, make BLANK cartridges 3. Take the blanks to a safe area. Load them with some kind of wadding tamped over them. Newsprint or cleaning patches work well. Remember to pickup afterwards. 4. Test for ignition and RECORD your...

Silver solder will probably be necessary.

I need help understanding your abbreviations please. “WD,S NEVER OIL NEVER in bbl leads to shellac on wds after” Is this referring to WD-40? What is the shellac on? I assume it is the inside of the barrel. Thanks, Chuck