rodwha
58 Cal.
I must not be looking in the right places as it seems all of the barrels I've seen cost over $200 and often need more work.
I only have 2 molds as of yet, though I intend on buying a 4 cavity custom mold with 2 different conical designs from Accurate for my ROA.
I asked him to make a FN conical with an OAL as that of a .457" RB so as it wouldn't take up any powder capacity. It came out at 180 grns (if cast in WW) and .460" long. I may adjust the dimensions a little.
http://www.accuratemolds.com/bullet_detail.php?bullet=45-180S-D.png
The other will be a 250 grn FN.
He also, after seeing that initial conical result in a 180 grn projectile, had him redesign it as a 160 grn, which I was initially thinking.
http://www.accuratemolds.com/bullet_detail.php?bullet=45-160B-D.png
And then I'll likely get a 320 grn .50 cal REAL mold as my rifle seems to enjoy spitting them down range!
I only have 2 molds as of yet, though I intend on buying a 4 cavity custom mold with 2 different conical designs from Accurate for my ROA.
I asked him to make a FN conical with an OAL as that of a .457" RB so as it wouldn't take up any powder capacity. It came out at 180 grns (if cast in WW) and .460" long. I may adjust the dimensions a little.
http://www.accuratemolds.com/bullet_detail.php?bullet=45-180S-D.png
The other will be a 250 grn FN.
He also, after seeing that initial conical result in a 180 grn projectile, had him redesign it as a 160 grn, which I was initially thinking.
http://www.accuratemolds.com/bullet_detail.php?bullet=45-160B-D.png
And then I'll likely get a 320 grn .50 cal REAL mold as my rifle seems to enjoy spitting them down range!
Last edited by a moderator:
