Adjust half **** on TC Hawken

[bat119]

Is there some way of adjusting the half **** hammer position?
On one of the 54 Hawken's the hammer is too low to cap without pulling back the hammer then easing it down, not my favourite way of capping

 

[BruceHH]

Short answer, no there is not.

 

[Kansas Jake]

Most of my TCs can’t be capped at half ****. Just the way they were made.

 

[Splitear]

Not at all uncommon. Both my TC Hawken and New Englander are that way, the hammer is barely off the nipple at half ****. I don't believe there's a way to change that.

 

[akroguy]

My GPR is like that. Seriously annoying.

 

[bat119]

Ok that answers that, on my others there's some room this one is really low oh well I'll live with it
Thanks for the reply's

 

[Phil Coffins]

The only way I can think of is make a new sear that has the tip longer, then both the half **** and full will be higher.

 

[TDM]

That problem is common to TCs @bat119

 

[Buckskinquin]

Is there some way of adjusting the half **** hammer position?
On one of the 54 Hawken's the hammer is too low to cap without pulling back the hammer then easing it down, not my favourite way of capping

I just checked my L&R replacement lock on my Renegade, no room to cap at half **** with it either.

 

[OldRust]

@bat119 Check your nipple. TC had an early and a late hammer on their percussion locks. The early used a longer/taller nipple and the later took a shorter nipple. You may have a later hammer with the early nipple. See the photo for the different hammers. The short TC nipple at Track of the Wolf also

Thanks,
O.R.