Another homemade peep

[Crow#21957]

I just made that one peep and then I had an idea how to do what I wanted.i will try an put these in order. Ok can I do about 6 or more pics?Flat steel bar. Grooved the end. Tapped a round piece of brass4/40thread. Soldered brass into grooved end of seel.

 

[Crow#21957]

Ok. Next step drilled hole in steel block and slotted now the flat bar and round brass slides into block

 

[Crow#21957]

Now I drill and tap for peep post and attatch brass block( block will get shaped to amall round to be tapped for atpeture. Once again I'm waiting on tap so I cand put this Arpeture in.

 

[Crow#21957]

The windage screw gets cut off up close to the nut.

 

[Ballshooter]

That looks good!

 

[Crow#21957]

Thanks Ballshooter. Here is another pic or two.the Allen wrench on the back is just holding the arpeture up until I get my 12/40 tap for it.

 

[ZUG]

Your on a roll now -- looks like you may need more bandages before this sight is completed

 

[Crow#21957]

I think you're right.lol