Maddog Avraham
32 Cal
I broke a finger in my left hand and can't hold on to a rifle now till it heals. Is it possible to use lead shot in Uberti Colt Walker for varmints?
While I can’t speak from personal experience with a cap & ball revolver shooting shot, I have witnessed shot shells fired in a rifled breechloader. It performed exactly as @OldNo7 described in post #4. The rifling makes the shot load spin, and once it exits the muzzle centrifugal force takes over and the pattern spreads, leaving a hole in the center. I’ve seen the results.I broke a finger in my left hand and can't hold on to a rifle now till it heals. Is it possible to use lead shot in Uberti Colt Walker for varmints?
It’s possible, question is effectiveness. Similar, but not the same as loading a percussion revolver, I have handloaded 44 and 45 caliber modern handgun ‘snake’ loads by using two pistol bullet gas checks to hold the shot, one over the powder the other at the mouth of the case with the mouths of gas checks facing each other (@denster suggested similar). When shot out of a pistol’s rifled barrel the load of #9 shot posed a grave danger to clay pigeons out to maybe 25 or 30 feet. I never did try the load on any snakes, but I was ready.I broke a finger in my left hand and can't hold on to a rifle now till it heals. Is it possible to use lead shot in Uberti Colt Walker for varmints?
i had a half a dozen or so pellets come flying back at me. Just bounced right of me but i wouldn't want to catch one in the eye.
I'd get some plastic shot cups from Speer and load them just like a conical. Should work great as they do in my .44 Mag revolvers.I broke a finger in my left hand and can't hold on to a rifle now till it heals. Is it possible to use lead shot in Uberti Colt Walker for varmints?
They’re not available currently… surprisingly… but perhaps you could use a wonder wad over powder and then a .463”x.030” veggie fiber wad over and under the shot load? It’s not difficult to get the card wads started, sort of tip them into the chamber and then use the ram to send them down.I'd get some plastic shot cups from Speer and load them just like a conical. Should work great as they do in my .44 Mag revolvers.
Well… I have a Smith. And a bunch of the plastic cartridges. What kind of load did you use?Give it a try! you're not going to damage anything. I made up several "rat shot" cartridges for the Smith carbine I used to have, and according to the coke cans I killed, they would have been deadly on snakes and vermin at rat-shot range.
Enter your email address to join: