Engraving

[Crow#21957]

Who do you know that would do some simple engraving on a patch box,, pipe,, butplate,,triggergaurd. I would like to get a price. I thought I could send these pieces to them and get a very simple design on them.
Thanks

 

[1sthound]

Who do you know that would do some simple engraving on a patch box,, pipe,, butplate,,triggergaurd. I would like to get a price. I thought I could send these pieces to them and get a very simple design on them.
Thanks

Do you have a design in mind? And are the parts cast brass or steel? Are the parts replaceable in case of shipping loss? I usually only engrave my own stuff but interested in what you have in mind.

 

[Crow#21957]

Pattern I don't care.Replsceable, yes
Steel or cast don't know. Part of a kit. Seems like steel would be better for engraving but that's just my guess.Dont care about fancy curves and such just a simple less is more.
Up to you to engrave. engrave.

 

[Crow#21957]

I've never had a ml with any engraving. Or carving for that matter. Iwould rather have a nice stock 4cm and some simple engraving on the metal.

 

[1sthound]

I can do it for you at a reasonable cost. I am not a master engraver but I do pretty good.

 

[Crow#21957]

I will get the kit ordered and have them send the steel parts asap. If you want to come up with a $ amount. Does it matter steel or cast or. Would I need to get the gunt together then take the parts off and send them?

 

[1sthound]

Doubt you will have a choice whether cast or not, Since it is a kit I'm sure they will be cast. No matter I will do it anyway. I have been on this site for years but do not post so I will figure out how to send a private message with the cost and my address. Don't want to post my info on an open forum. No need to build and then take apart to send the parts.

 

[Crow#21957]

Ok

 

[1sthound]

Doubt you will have a choice whether cast or not, Since it is a kit I'm sure they will be cast. No matter I will do it anyway. I have been on this site for years but do not post so I will figure out how to send a private message with the cost and my address. Don't want to post my info on an open forum. No need to build and then take apart to send the parts.

 

[1sthound]

I just tried to send you a private message did you get it?

 

[1sthound]

I just tried to send you a private message did you get it?

 

[1sthound]

oops

 

[Crow#21957]

Yes I got it . Thanks