Finishedish woodsrunner

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Mar 3, 2024
Messages
30
Reaction score
22
Location
Maine
My second attempt at a kibler kit after goofing the first. Tried to keep it pretty simple and within my skills. Basic walnut stock. Did spend some time with files on the brass cleaned things up. Birchwood Casey Super blue on the steel bits and barrel. Works alot better with heat (available locally also used to tarnish brass a little) . Left lock in the white while I waited on a vise.. but dont mind it. I don't know if my finish is good enough... I sanded down with 220 raised the grain and light sanded 6 times. Put 6 coats of truoil on it(two a day, morning and night) buffing with 000 steel wool between coats and wiping down with microfiber. One light coat of permalyn.. buffed again. It seems to bead water ok. I did finish the barrel inlet with a coat of truoil. Gun shoots very well sights as centered as I can get. There's some porcupines outback in the stone qaury on short notice
 

Attachments

  • 20241224_102719.jpg
    20241224_102719.jpg
    1.9 MB
  • 20241224_102729.jpg
    20241224_102729.jpg
    2.1 MB
  • 20241224_102608.jpg
    20241224_102608.jpg
    1.3 MB
  • 20241224_102557.jpg
    20241224_102557.jpg
    1.6 MB
Last edited:
The ramrod got an experimental finish dissolve steelwool in some vinegar to get it dark. Didn't come out dark enough so I used oak charcoal from the woodstove colored it with it. Buffed off the excess and coated with beeswax.. actually broke it trying to straiten it a little so had to repair it and seems to be holding up ok. New ones on the way
 

Latest posts

Back
Top