Hello Gentleman I have a Cabela's Blue ridge rifle. I have had nothing but problems with this gun since the get go.The rifle is a Pedersoli Fron tear and I believe that the spelling is accurate. Very shortly after I bought the rifle th ram rod broke.I know original ramrods are junk. I replaced it with a brass one. Then the touch hole liner was impossible to remove. The screw slot is too thin it cracked. I took it out everytime and coated it with never sieze before replacing it. I had to use an easy out to remove it and I have replaced it with an allen head type. This works fine. I have a 20 gauge pedersolli double barrel that is great.I think they make a quality product. I also have several other muzzleloaders that I shoot. I also can never get a group from this gun. I have fired around 500 rds from the gun. One time I did get a good group at 25yds. Three shots under an inch. This was after replacing the sights. I have never been able to repeat this. I have tried different patch thickness',different loads from 15 grains to 50 grains,3f and 2f, Cleaning between shots cleaning every third shot. The barrel is atached with two screws underneath I tightened them as tight as I can. Nothing makes a difference 3-4 inch group at 25 yards.The bore seems smooth no rough or tight spots. I bought the gun new. I am ready to throw this gun over a hill. I don't want to sell it for fear of putting someone through this same ordeal.I would not wish this on anyone. Do you guys have an idea or some secret I can try? I have been shooting blackpowder since the 70's and have never had a situation like this.