This is a basic primer for making a Powder Horn.
Part 1 is the basic build.
Part 2 (coming next) will be the decorating (scrimshawing) and finishing.
Hope this is interesting.
Making a Powder Horn, Part 1
The first step (after selecting a horn) was to locate the end of the hollow at the tip of the horn. I just use a metal wire to do that. Then, after marking that point, I add about an inch or so of length to make the cut. This will allow material for some tip shaping and enough room to hold the plug snugly.
I then use a 1/4" drill bit and aim it down the horn to where it will hit the inside cavity.
Part 1 is the basic build.
Part 2 (coming next) will be the decorating (scrimshawing) and finishing.
Hope this is interesting.
Making a Powder Horn, Part 1
The first step (after selecting a horn) was to locate the end of the hollow at the tip of the horn. I just use a metal wire to do that. Then, after marking that point, I add about an inch or so of length to make the cut. This will allow material for some tip shaping and enough room to hold the plug snugly.
I then use a 1/4" drill bit and aim it down the horn to where it will hit the inside cavity.
