Hey guys, brand new here with a problem. Ive had muzzleloaders a long time, and I just got a tc hawken but it has a mag spark on it. Never seen one before but I dont like the idea of it and I also dont have any pistol primers so i want it off, but when I tried to unscrew it the allen hole stripped under moderate pressure. Any advice how to get this thing off.
-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
Mag spark stuck
- Thread starter Flathead85
- Start date
Help Support Muzzleloading Forum:
- Joined
- Jun 7, 2017
- Messages
- 1,401
- Reaction score
- 1,824
If you don't care try some pliers to unscrew it. That's if you're not saving it.also might spray some kind of lubricant around the base before you try
Last edited:
Do try some sort of thread penetrating solution. A 50/50 mix of acetone and automatic transmission fluid is about the best. Let it work for a few days with fresh applications applied at intervals before taking the heavy-duty vise grips to it.
x2 for vise grips
Can you cut a slot in it and use an impact driver? Before you try anything drastic, be sure to put the barrel in a padded vice. Just saying. Another thought - drill it a little bigger and use an easy out.
Hope it wasn't shot 5 years w/o removing for cleaning. A lot of folks never remove the "clean out screw" and after 6-7 trips to the range it aint coming out. BTW for those about to netwhack me for calling it a clean out screw....many vendors now mention the "clean out screw" in the product descriptions.
Sooty Scot
40 Cal
- Joined
- May 2, 2022
- Messages
- 233
- Reaction score
- 173
Pull the barrel. Sink it in a sealed, capped section of PVC (upright).
Fill to above the offending"nipple" w/ Evaporust.
if the barrel doesn't fill, fill it that deep.
Let it soak a few days, then try unscrewing the fitting again.
Padded jaws on a solid vice,as others advised.
Best stuff I've found; near magic but some joints do resist.
Fill to above the offending"nipple" w/ Evaporust.
if the barrel doesn't fill, fill it that deep.
Let it soak a few days, then try unscrewing the fitting again.
Padded jaws on a solid vice,as others advised.
Best stuff I've found; near magic but some joints do resist.
Thanks guys I got it off disregard rhe duplicate post I couldnt find it earlier I didnt think it went through not good with computers
Ive had good luck with Kroil
Good job,, hang around,, there might be a thing or two you could teach us!
