Mystery part?

[Traddawg]

Took my barrel off and this came out as well. Does anyone know what it is?

 

[renegadehunter]

A picture didn't come through with your post.

 

[Traddawg]

Does anyone know what this is it was under my barrel?

 

[S.Kenton]

I beleive that puts pressure on the ram rod and keeps it from sliding out. Ramrod tension spring

 

[deermanok]

Ramrod retention spring.

 

[bubba.50]

Ramrod spring for a CVA rifle. Front lock screw is ‘sposed to go through it to hold it in place.

 

[hanshi]

Yep, ramrod retention spring.

 

[Traddawg]

Thanks new and ignorant lol

 

[ADK Bigfoot]

Ignorant is a state of mind. Uneducated is a temporary condition. Nothing wrong with being new. We all were once. Reject ignorance. Embrace learning. And welcome to a wonderful living encyclopedia of knowledge.

ADK Bigfoot

 

[deermanok]

Were you able to put it back in where it goes?

 

[Traddawg]

Were you able to put it back in where it goes?

Not yet lol working on refinishing the barrel right now just glad to know what it is lol

 

[Traddawg]

Ignorant is a state of mind. Uneducated is a temporary condition. Nothing wrong with being new. We all were once. Reject ignorance. Embrace learning. And welcome to a wonderful living encyclopedia of knowledge.

ADK Bigfoot

Ignorant is a state of mind. Uneducated is a temporary condition. Nothing wrong with being new. We all were once. Reject ignorance. Embrace learning. And welcome to a wonderful living encyclopedia of knowledge.

ADK Bigfoot

Thanks

 

[mooman76]

That part is to assist in holding the ramrod in place. Many guns don't even have them. If your gun holds the ramrod in place without it, I wouldn't even bother putting it back.

 

[OhioHawkeye]

I don't think any of my guns have this. I do have one that could use it.... usually just steam bend the rod a bit for that one when I have needed a new rod. I wonder if something like that could be added to mine instead...ummmmmmm????

 

[dragnetbill]

Took my barrel off and this came out as well. Does anyone know what it is?

If you decide to re-install it you should look up a schematic and pay attention to how it goes in; if you put it in upside down it can declare a tug-of-war for your ram rod.

 

[rafterob]

I leave them out of my CVA guns and rely on the slightly bent ramrod method.