Non-Dovetailed Rear Sight?

[jlutz]

I made one for a T/C Hawken out of 1/16 flat steel and drilled holes to fit the spacing of the holes on the barrel. Made a small step elevator out of the same stock metal. Works fine for me.View attachment 86733

I like it! Looks like a good option.

 

[SDSmlf]

I bought a half dozen of these a while back that did NOT have the holes predrilled. The holes were an extra charge (maybe $10 or $15 extra - forget exact number), but I can’t recall the vendor at the moment. You may want to do some searching, you could get lucky.

Thinking about it a bit, I believe I got the sights sans holes from the Hawken Shop, though unfortunately, like many other items in our little corner of the Earth, the sight shows out of stock right now. Conversion rear sight - The Hawken Shop

 

[jlutz]

Thinking about it a bit, I believe I got the sights sans holes from the Hawken Shop, though unfortunately, like many other items in our little corner of the Earth, the sight shows out of stock right now. Conversion rear sight - The Hawken Shop

Thank you, I appreciate it!

 

[bubba.50]

Thinking about it a bit, I believe I got the sights sans holes from the Hawken Shop, though unfortunately, like many other items in our little corner of the Earth, the sight shows out of stock right now. Conversion rear sight - The Hawken Shop

I'm pretty sure that's where I saw them listed too. Maybe they'd give ya the address/email of the supplier to check if they even still make them?

 

[Grimord]

Thank you. Do you happen to know where? I haven’t been able to locate it searching online.

Try the Hawken Shop.