I am looking to buy a complete rectangular TC rear sight with notch. Please let me know if you have one. Thanks
-
If you have bought, sold or gained information from our Classifieds, please donate to Muzzleloading Forum and give back.
You can become a Supporting Member which comes with a decal or just click here to donate.
WITHDRAWN rectangular TC rear sight with notch wanted
- Thread starter Jimbob
- Start date
Help Support Muzzleloading Forum:
- Status
change your heading to WANTED. what c to c screw spacing? blade type correct?
I didn't even know it got listed as "for sale" and do not see how to change it to "wanted".
The c to c screw spacing is standard TC. I don't have a measurement because I don't have the barrel in hand yet. The blade type is a rectangle with a notch.
I have two different ‘standard’ center to center spacing for the rear sights on my TC barrels. Depends on the vintage of the barrel. And are you looking for the rear sight with the flat partridge style (many call this the Renegade style) or the semi buckhorn intended for use with a beaded front sight (usually found on the TC Hawken)? Not to mention that TC had different sight bases for the 15/16” and 1” ATF barrels.
You may want to wait until you have the barrel in hand. Then you can go about getting what you actually need instead of what you think you may need. More than one variation of TC sights during their production run. Might even want to post a photograph of what you want.
I had no idea TC had more than one spacing for their rear sight holes. I will take your advice and wait until I have the barrel in hand then get back to you. Thanks for your help.
Terry Lightle
40 Cal
- Joined
- Apr 16, 2019
- Messages
- 252
- Reaction score
- 300
What he said,best to wait
Possibly. I would have to see the face of it and does it come with mounting screws?
Here are some pictures of what I am looking for -
That's a Renegade sight and you still need the hole spacing.
And the bases are different for the 1” and 15/16” barrels.
- Joined
- Dec 15, 2016
- Messages
- 1,569
- Reaction score
- 3,975
Figure out what you need, if the folks above me don't have it, there is a slim chance I may have it. I purchased several T/C sights at a gunshow at the KC Hall, used some, sold some, not sure what I have left, but I can take a look if you come up short handed.
Thank you all. I’m not buying the barrel I was going to need the sight for so my want ad is withdrawn.
Well that’s disappointing. This could have turned into one of those stuck ball type threads.
Yes, they are at least on the Hawkens. I think most if not all Renegades are 1".
- Status
Similar threads
- Locked
- Locked
