Does anyone have 7196 TC peep sight that was made for the Cherokee and Seneca rifles? If so I would like to know the width. I have a TC made rear peep but I am not sure if it was made for the full size rifles or the smaller rifles. My sight measures .500. It looks like it could be used on either one.
-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
Seneca Cherokee peep width
- Thread starter Riggerjon
- Start date
Help Support Muzzleloading Forum:
kelvinator
32 Cal.
I have a TC tang peep sight, no idea of the model #, but the base measures .500" wide also.
It was mounted on a Renegade and fit well.
It was mounted on a Renegade and fit well.
It looks like mine is for the full size Hawken. I had it mounted on a Cherokee for a while and it worked fine but is a little wider than the tang on that rifle.
- Joined
- Apr 4, 2010
- Messages
- 1,061
- Reaction score
- 482
I have one of these sights and my snivel is that there seems to be no lock elevation wise. Wind age is accomplished by loosening the eye cup and manually move it side to side , then tighten the eye cup buy9 the elevation screw has no apparent lock for it.
Mine also is the
.500 inch base which makes it a large.
Edit;
Looks like I may have jumped in prematurely here. My peep is the vernier type that TC had available for the Hawken rifle. Srry if I derailed this thread.
Mine also is the
.500 inch base which makes it a large.
Edit;
Looks like I may have jumped in prematurely here. My peep is the vernier type that TC had available for the Hawken rifle. Srry if I derailed this thread.
Last edited:
Similar threads
- Locked
