TC Tang Sight

[Hatchet Jack]

Before filing down the sight or cutting away any wood, try shimming the sight first.
I made my shims out of aluminum for my Renegades. I cut them from a solid aluminum block. I made them the entire length of the peep sight. The shim on one of my Renegades is a lot thicker than the shim on my other Renegade. Shim heights will vary from gun to gun. It is mostly trial and error and a lot of filing down of the shims.
I had to drill and tap an extra hole in each one of my tangs order to install my 57SML sights.
I will try to add pictures.

 

[Chmachin]

I am going to do this to a couple of my rifles. Which front sight do you use?

 

[Hatchet Jack]

I am going to do this to a couple of my rifles. Which front sight do you use?

I use the green 3/8 dove sight from Rangerpoint. The fiber optic is a little smaller at .04”.
See link below

https://rangerpointstore.com/news/ranger-point-precision-announces-new-fiber-optic-rifle-sights/

 

[Dirty Mike]

Early ones had the 3 hole for tc hunter peep but the Willis and lyman fit it great also