Trigger Guard Question

[LRB]

Me too, or close enough. 1175° silver braze.

 

[fosters]

You all are 100% accurate. Been so long since I looked at it, was 50+ inches of snow between me may workshop til recently, I should have said Berks County style. Proves I need to study up on my "Schools" too. The casting isn't really that well defined, I guess it is more of a shouldered bullet on the front and rear of it. I guess I'll have to break out the needle files and enhance the cast when I get to that point.

Anyhow there still is no rear tenon/tab. They supplied a wood screw to attach the rear and mentioned both screw and pin would be correct. I'd like to go with the pin so I guess I'll try soldering on a piece of 1/8" brass or by a brass lug and cut a piece off it to attach. Will a regular propane blow torch work? I have no access to Map.

Truly sorry for the misinformation and thanks again for the help. That is a fine looking Beck though, I hope my 1st try comes out as well.

Your Servant
fosters