So there it sits...waiting for some iron on the butt. And brown on the barrel, tenons too. Maybe a nipple guard....the hammer casting is a little canted. Rod pipes...sights...nipple. Whew.
UnderHammer
- Thread starter Cyknife
- Start date
Help Support Muzzleloading Forum:
I have the brass flash guard, I took them off. I had bad time tring to get the perc. cap pushed on nipples after I have to pinch them to stay on. Think my nipples are abit small. I took a soda can & cut a sq. from it & drilled a hole for nipple threads to go through. Think I need to find a better & thicker ga the soda can aluminum is too thin.
Man, you are killin' it with this project. Looks GREAT! Keep the posts coming!
The Devil made him do it,
I have furthered the cause....found an actual H&A barrel in 50 complete. Pin style tho' it did mount.
I done collected some barrels. Found an original HA in 50....a green mountain 50 oct. to round slow twist and a cva 45 rescue. Also got a block o maple to match the stock. The 45 cva may go back to the original rifle as it might be worth restoring. That's another project.....
Attachments
Last edited:
Plenty to try out for sure.
The Green Mountain 50 is an 1 1/8 ATF to 1" at the muzzle. It is a 1-60 rate for ball. Very heavy...it's the bench barrel. Gun clock's in at 9.5 lbs with that barrel. The 54 with der Kibler forearm only weighs 6.6 pounds. Started the butt plate group....
Attachments
Last edited:
Got the buttplate and shoulder screwed to the stock. Am thinking to leave them in two pieces as they fit very closely and no heat on these bits won't effect the finish.
Nice!!!
Similar threads
