I have an old knight inline that someone mistreated , I want to bore out to make a 28 ga. .Can I bore it out with a 35/64 bit welded to a rod and held in place with a vice or would I also need to use a reamer to smooth out the bore? Comments please.
-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
wanting to make 28ga inline smoothbore
- Thread starter R.Boone
- Start date
Help Support Muzzleloading Forum:
- Status
Metalshaper
40 Cal.
- Joined
- Jul 6, 2004
- Messages
- 479
- Reaction score
- 132
armourers square reamer would be slow but would do the trick! plus it wudn't bite in and drift on you either. Lots of oil and patience..
Respect Always
Metalshaper/Jonathan
Respect Always
Metalshaper/Jonathan
- Joined
- Nov 26, 2005
- Messages
- 5,224
- Reaction score
- 10,884
Hi,
You should check out the rules. Discussions of inlines is not permitted on this forum as per rule #7 below:
https://www.muzzleloadingforum.com/threads/forum-rules.108881/
dave
You should check out the rules. Discussions of inlines is not permitted on this forum as per rule #7 below:
https://www.muzzleloadingforum.com/threads/forum-rules.108881/
dave
dave's right. We don't discuss in-line guns and this includes modifying them.
- Status
Similar threads
