what patch to use?

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

tdoyka

32 Cal.
Joined
Jun 18, 2013
Messages
78
Reaction score
25
i need to use a .005" patch for my CVA Hawken. i was wondering what other kind of home made patches used for?

rifle cleaning patch for .17 cal. is .008"
notebook paper is .002"
toilet paper is .015"
used drier sheet is .004 to .006"
paper receipt from pharmacy is .003"

i have some .005" patches ordered, but i want to shoot my FL rifle and i only got 12 patches that are .005". i was thinking an over patch (.015") and then a drier sheet with the RB. can it work or never do it. just wait till the patches show up.
 
i need to use a .005" patch for my CVA Hawken. i was wondering what other kind of home made patches used for?

rifle cleaning patch for .17 cal. is .008"
notebook paper is .002"
toilet paper is .015"
used drier sheet is .004 to .006"
paper receipt from pharmacy is .003"

i have some .005" patches ordered, but i want to shoot my FL rifle and i only got 12 patches that are .005". i was thinking an over patch (.015") and then a drier sheet with the RB. can it work or never do it. just wait till the patches show up.
Why so thin a patch? Might burn through hurting accuracy.
 
You will not be happy with .005” patch, any kind of paper will be less than effective. Change ball size to use a thicker patch.
I agree because you need a patch thick enough to really grab that rifling on the way out. It needs to compress into the grooves, and given that most rifling is already nearly that deep or even deeper, there's little compression of the patch into the grooves with that thickness.
 
Last edited:
I but 500 packs of prelubed patches for 33? bucks from ebay. Eastern Maine shooters supply I think.
I get .015, and they perform 100%. Go down easy, and clean up well. They have every thickness and caliber, and quantity. I would rather shoot than mess with making patches, but I can see wanting to do it yourself. Anyway it works for me.
I agree with the other gentlemen, get a smaller ball to get more patch in the rifling. That keeps it clean and consistent.
 
my ball is .488". if you go to thicker patch, like .010", you will be able to shoot a couple of times and then the only way to get them down the barrel is a rod and mallet. i do a cloverleaf pattern at 50 yards and no burn thru. if i want, i could reuse the patches. i use 70.0gr Goex FFg powder. i have alot of it

i have a cotton Hankee that measure .005 - .007". i am going to try that.
 
If I don't get water vapor down after each shot It is almost impossible to load twice. I good blow and I can go as long as I like. Personally I can't cuff more than 40 shots. I get about 1 shot per 2 minutes, so I usually stop at 45 -60 minutes. The range is a few miles away, so I can go twice a day if I want to burn powder.
 
You need a patch thick enough to compress and grab and fill the rifling, while gripping the ball tightly enough to impart a spin to the ball upon firing. An .005 patch is way too thin and will most likely just tear up on its way down then out the bore.

I'm assumimg your gun is in .50 caliber. You should be able to use an .015 patch with a .488 ball and still get it down the bore fairly easily.
 
Back
Top