Search results

PM sent

It is a contemporary KY pistol likely made from the 1970s forward judgeing from the style and materials used. Likely a good shooter if the bore is clean.

PM sent

I will take it PM and text outgoing.

Actually that is .18 each!

L will take it. PM sent.

Before a moderator takes you to task. You need to include a card with your screen name and date along with the rifle per forum rules.

Don't bother checking the ID the taper is not reciprical. The taper on the arbor was just Uberti's quick fix for the short arbor. Also one of the reasons it is often hard to get the barrel off of a new or recent Uberti because it has been forced onto the taper by the wedge. Stays that way for...

SOLD!! Thanks Mike

Responded to PM

A few more photos.

I have for sale an early Pedersoli 12 Ga. side by side shotgun. As near as I can tell the date code is XX which would be 1964 I will include some photos of the date code for those with sharper eyes than mine. For a gun this old this is in really exceptional condition. The bores are both bright...

Nothing about it on buffalo bills site.

I really like osage particularly after I located a fellow that was selling billets cut on a Southern military base that had late wood rings from1/8 to 1/4 in. Still have 20 sets of sister billets from that lot. Best preformance though was from bamboo backed osage glued up with about a 2" reflex...

Careful! Wood bow making is every bit as adictive as muzzle loading. I'm here to testify!

The problem is at the point the barrel is about to contact the frame the arbor diameter increases slightly so the barrel can't go on any further. This was Uberti's half assed solution to the short arbor problem. The wedge when driven in forces the barrel onto this oversize diameter and it is...

That is a mis listed 1862 Police. An older gun made for the now defunct Western Arms. would want to see the bore and cylinder condition as it looks like it has had some abuse.

Well Mike looks like this is the only thank you forthcomming!

It is entirely possible. Cut you powder charge to 20gr seat a .451 copper gas check over the powder with cup facing out, load #9 shot to just below the mouth of the chamber then seat another gas check cup facing down over the shot use a little pressure and the gas check will expand to seal the...

I believe he was taking smokey plainsman to task for posting on your for sale add a link to the same item new for less than you are asking. That is considered bad form.