Just yesterday I was thinking to myself that those screws looked pretty flimsy and I should switch them out, unfortunately I didn't look any farther than the local hardware store which didn't have anything small enough.
Sure enough, I torqued the top off of one last night . Of course after the fact I found an old post of Mykeal's warning about this.
Anyway, before I proceed in any particular direction does anyone have any advice? I don't think the screw is possible to pull due to the small size and it being flush with the wood where it broke.
Sure enough, I torqued the top off of one last night . Of course after the fact I found an old post of Mykeal's warning about this.
Anyway, before I proceed in any particular direction does anyone have any advice? I don't think the screw is possible to pull due to the small size and it being flush with the wood where it broke.