Carbon Ball Bearings

[JohnCanadian]

I would prefer to use lead round balls. If that's not an option would ball bearings "work". I'm looking at getting a 4 bore and can't find a mold let alone precast round balls.

 

[Britsmoothy]

Sure, just don't get one stuck part ways down!

 

[JohnCanadian]

I thought about that. I'm going to make a rod with really high power magnets (that can lift 20") and use that as a ball grabber. This is mostly a wall hanger and turkey gun anyways.

 

[Robby]

https://www.ballmoulds.comhttps://www.thereloadersnetwork.com/2018/10/09/jt-bullet-moulds-670-round-ball-mold/I think this is the fellow I have used in the past for oversized round ball molds. (Jeff Tanner?). They are excellent. Make sure you have the correct diameter of your four bore, they can vary a bit. Good Luck!!!
Robby

 

[Grenadier1758]

I thought about that. I'm going to make a rod with really high power magnets (that can lift 20") and use that as a ball grabber. This is mostly a wall hanger and turkey gun anyways.

The magnets will be as likely to grab the barrel as the ball bearing.

 

[Alexander Efremenko]

I would prefer to use lead round balls. If that's not an option would ball bearings "work". I'm looking at getting a 4 bore and can't find a mold let alone precast round balls.

Jeff Tanner in England will.make you a mold of any size. At reasonable prices