Carved Whitetail Antler

[Dutchman58]

60 grain powder measure.

 

[Roy]

:thumbsup: Nice.

 

[omarick1948]

Very nice and clean crisp file work :thumbsup:

Tell us how you made it...Enquiring minds want to know!

WELCOME TO THE FORUM!

 

[RickD]

Very nice

 

[rabjr]

Nice! :thumbsup:

 

[jethro224]

Nice work Dutchman! :thumbsup:
Every rifle deserves a nice antler powder measure.

 

[GreyWhiskers]

Very nice. :thumbsup: What'd ya use to hollar out the center? GW

 

[Dutchman58]

Very nice and clean crisp file work :thumbsup:

Tell us how you made it...Enquiring minds want to know!

WELCOME TO THE FORUM!

Thanks everyone.

Making this one was simple. Put it in a padded vise and drilled the center with a 5/15 bit and used a Dremel High Speed Cutter to bore it out.

Used a triangular shaped file, a small one to do all of the carving. No big deal if you use a pencil to draw the lines you intend to file before you start cutting.

Sanded it with 150, then 220 grit sandpaper and polished it with Crest Whitening Tooth Paste and my wife's tooth brush. :grin:

Sorry I didn't include this in the original post. I'm getting the hang of this thing around here a bit slowly. :wink:

 

[Roy]

Well dang, your near by... didn't get hit by the storms I hope?..

 

[RickD]

Where in Gainesville are you?I`m also from Gainesville

 

[RC]

:thumbsup: VERY NICE!!! :hatsoff:

 

[Dutchman58]

Where in Gainesville are you?I`m also from Gainesville

I see that! I live off of Poplar Springs Road.